When removing my ED6 harness I could not undo the shock tower connector, so at the time as I wasn't using the harness no more, snip snip cut it inside cabin. Annnnnd of course, now I need to reuse it! Luckily I labelled wires both ends where I cut them, so I just had to solder them back together, followed by heat shrink and then electrical tape:

14/4/2016

Wired up the rest of the "cut up" ED6 loom, from where I was going to adapt the DA9 OBD1 complete harness into, until plans changed.. Pic of doing the rear harness:

18/4/2016

With the cabin harness done, I started working on tucking the head lights/indicators etc. There was a black rubber plug behind the fender which I popped out. Might drill a hole in it and put back on, then add some gasket sealant in case any water attempts to go in. Here's the progress pics so far..

Drivers side isn't completed yet as I'm keeping in mind having to run wires for the radiator fan switch, so I might run them through here as well:

Passenger side I finished off straight away as it's only the lights:

To finish this off I worked on removing the ED carby fuel tank, that was not fun at all as a first timer..